Grizzly G0700 - Manual (Page 42)

-40-
Model g0700 (Mfg. since 8/09)
the miter fence is graduated in 5˚ increments
and can be angled anywhere between 45°L and
45°r.
the angle of the miter fence is adjusted by loosen-
ing the lock handle (
figure 63), rotating the fence
to the angle shown on the scale, then tightening
the lock handle to secure it in place.
miter cutting
3. position the flip stop according to the length
of the workpiece you want to cut off to the left
of the blade.
4. Load the workpiece onto the table saw
(similar to figure 65) and perform the cutting
operation in the same manner as a crosscut.
figure 65. Fence set-up for 45°L cuts.
figure 64. Fence set-up for 45˚r cuts.
to perform a miter cut:
1. install the miter fence on the sliding table.
2. position the miter fence at the desired angle
for the cut and lock it in place. figures 64–65
show the miter fence set up for 45° cuts in
both directions.
figure 63. Miter fence.
Lock handle
scale