Grizzly G0700 - Manual (Page 28)

-26-
Model g0700 (Mfg. since 8/09)
30. run the 2½" hose over the hose support, as
shown in figure 29.
figure 29. dust hose support in use.
figure 30. Consolidating dust lines with optional
dust collection accessories from grizzly.
tip: the two dust ports can be connected
together at the machine with the optional
grizzly accessories shown in
figure 30.
h1215 4" Quick
Fit sleeve
t20559 2 1 ⁄
2
" x
4" x 4" y-Fitting
29. secure a 4" dust hose to the dust port located
under the saw table and the 2 1 ⁄
2
" dust hose to
the blade guard (see figure 28).
figure 28. dust hoses attached.
2 1 ⁄
2
" hose
4" hose
NOTICE
minimum cfm at 4" dust port: 400 cfm
minimum cfm at 2 1 ⁄
2
" dust port: 150 cfm
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust col-
lector, (2) hose type and length between the
dust collector and the machine, (3) number
of branches or wyes, and (4) amount of other
open lines throughout the system. Explaining
how to calculate these variables is beyond the
scope of this manual. Consult an expert or pur-
chase a good dust collection "how-to" book.