Grizzly G0700 - Manual (Page 39)

Model g0700 (Mfg. since 8/09)
-37-
this saw has the capability of rip cutting large
panels, as shown in
figure 54. the sliding table
removes the burden of sliding a large and heavy
panel over a stationary table surface.
this saw also has the capability of rip cutting in
the same manner as a traditional table saw, as
shown
figure 55.
rip cutting
figure 54. rip cutting with the sliding table.
figure 55. traditional rip cutting.
rip cutting with sliding table
1. install the miter fence on the sliding table, as
shown in figure 56.
2. adjust the fence angle to 0˚, using the angle
scale on the miter gauge. if the cut requires
extreme precision, adjust the miter fence as
described in
squaring miter fence to blade
on page 65.
3. adjust the miter fence so it does not extend
into the cutting path of the blade.
4. set the flip stop to the desired width-of-cut.
5. Load the workpiece onto the table saw. the
set up should look similar to figure 54.
6. adjust the height of the main blade
approximately 1 ⁄
8
"– 1 ⁄
4
" above the top of the
workpiece.
7. take all the necessary safety precautions,
then perform the cutting operation.
figure 56. Miter fence mounting locations.