GE Monogram 164D3333P095 - Manual (Page 8)

8
Oven Control, Clock & Timer
Wall Oven
To set the
clock
1 Press the CLOCK ON/OFF pad.
2 Press the number pads the same way you read
them. For example, to set 12:34, press the
number pads 1, 2, 3 and 4 in that order.
If number pads are not pressed within one
minute after you press the CLOCK ON/OFF
pad, the display reverts to the original setting.
If this happens, press the CLOCK ON/OFF
pad and reenter the time of day.
3 Press the START pad. This enters the time
and starts the clock.
To check the time of day when the display is
showing other information, simply press the
CLOCK ON/OFF
pad. The time of day shows
until another pad is pressed.
Clock
The clock must be set for the automatic oven timing
functions to work properly.
The time of day clock cannot be changed
during Delay Start. (It can be changed during a
regular bake or broil operation.)
Timer NOTE: The timer is independent of all the other
functions and it does not control the oven. The
CLEAR/OFF pad does not affect the timer.
You may program the timer to time cooking or
other household activities for up to 9 hours and
59 minutes.
The timer counts down in minutes, 1 minute at
a time, until the last 60 seconds are reached.
Then the control will beep one time. The
seconds will not be displayed until the last
minute is reached.
When the timer reaches “ :00,” the control will
beep 3 times followed by one beep every 6
seconds until the KITCHEN TIMER ON/OFF
pad is pressed.
The 6 second tone can be canceled by
following the steps in the Special Features of
Your Control under Tones at the End of a
Timed Cycle.
Power
failure
If a flashing time of day is in the display,
you have experienced a power failure. Reset
the clock. To reset the clock, press the CLOCK ON/OFF
pad. Enter the correct time of day by pressing
the appropriate number pads. Press the
START
pad.