GE 25833 - Manual (Page 20)

20
NOTE: If handsets have been named, then the name will be displayed on LCD
instead of handset numbers.
NOTE: During the room monitoring, it will emit a beep tone if there are incoming
calls. You may press TALK•CALL BACK button to answer the call and quit the
room monitor mode.
NOTE: Press the * EXIT button on the handset to exit the room monitor.
NOTE: After you initiate the room monitor, you can switch to use handset’s
earpiece to do the room monitoring by pressing the TALK•CALL BACK button on
the initiating handset.
Handset Setup
You may program the following items:
Language, Handset Name, Ringer Tone, Ringer Volume, VIP Melody, Key Tone ON/
OFF, Message Alert, Rings to Answer, Security Code, Area Code, Registration, De-
Registration and Default Setting.
During programming, you may press the *EXIT button at any time to exit and keep the
previous setting.
NOTE: Programming for New Message Alert, Rings to Answer, and Security Code
features, can ONLY be done with the 25833A handset, these functions cannot be
programmed using the optional 25832A handsets.
Language
1. Make sure your phone is OFF (not in talk mode).
2. Press the MUTE/PROG button to go to the main menu.
3. Press CALLER ID-VOL ( or ) button to scroll to HANDSET SETUP.
4. Press MUTE/PROG button to confirm.
5. Press MUTE/PROG button to enter the menu. SET LANGUAGE 1ENG 2FRA 3ESP
shows in the display.
6. Use the touch tone pad on the handset to select 1ENG, 2FRA, 3ESP or use the CALLER
ID-VOL ( or ) button to scroll to the desired language. English is the default setting.
7. Press the MUTE/PROG button to save your selection. You will hear a confirmation tone
and the selected language shows in the display.
Handset Name
1. Make sure your phone is OFF (not in talk mode).
2. Press the MUTE/PROG button to go to the main menu.
3. Press CALLER ID-VOL ( or ) button to scroll to HANDSET SETUP.