GE 25833 - Manual (Page 27)

27
9. Press the touch-tone pad to select 1YES or 2NO, or use the CALLER ID-VOL (or)
button to scroll to 1YES or 2NO.
10. If you select YES, press the MUTE/PROG button to confirm. DE-
REGISTER ..... shows in the display followed by a confirmation tone. Then HANDSET X
DEREGISTERED shows in the display to confirm the handset is deregistered.
NOTE: When you complete the deregistration process, “HANDSET NEEDS
REGISTRATION” shows in the display. To use the handset, you must register the
handset.
Global De-registration
If one or more handsets becomes lost, you should de-register all handsets to ensure
proper system operation. Follow the steps below to deregister both handsets at the same
time.
WARNING: It is not recommended that a handset be de-registered unless
absolutely necessary because once a handset is de-registered, that handset’s
telephone features cannot be used until the handset is re-registered.
NOTE: Before starting global de-registration procedure, let all handsets sit idle for
20 seconds.
1. Press and hold the PAGE button on the base until the CHARGE/IN USE indicator on the
base flashes.
2. Press and hold the PAGE button on the base again until the CHARGE/IN USE indicator
on the base flashes rapidly.
3. Press and release the PAGE button on the base once. All handsets are de-registered
and HANDSET NEEDS REGISTRATION shows in the display.
Default Setting
As you become familiar with this system, you may prefer to use the system’s original
settings. Follow the steps below to return to the factory default settings.
1. Make sure your phone is OFF (not in talk mode).
2. Press the MUTE/PROG button to go to the main menu.
3. Press CALLER ID-VOL (or) button to scroll to HANDSET SETUP.
4. Press MUTE/PROG button to confirm.
5. Press the CALLER ID-VOL (or) button to scroll to the DEFAULT SETTING menu.
6. Press the MUTE/PROG button to enter the menu. DEFAULT SETTING 1YES 2NO shows
in the display.
7. Use the touch-tone pad to select 1YES or 2NO, or use the CALLER ID-VOL (or) button to
move the cursor to 1YES or 2NO. 2NO is the default setting.