Grizzly 12" Cold Cut Saw G0682 - Manual (Page 17)

g0682 12" Cold Cut saw (mfg. since 12/10)
-15-
Assembly
assembly consists of assembling the stand (if
necessary), mounting the machine, and attaching
the handle, support roller, and work stop.
To assemble the machine:
1. attach the front panel to one of the side pan-
els with three m8-1.25 x 20 hex bolts, nuts,
and six flat washers, as shown in
figure 10.
figure 10. Front and side panels.
2. attach the remaining side panel in the same
manner as Step 1, as shown in figure 11.
figure 11. second side panel attached.
Front panel
side panel
side panel
once the stand is assembled (see Assembly) it is
ready to be mounted to the shop floor.
To mount the stand to the floor:
1. drill four holes in the inner lip at the bottom of
the stand in the approximate locations shown
in
figure 9. be sure the holes are large
enough for the anchor method you choose.
figure 9. mounting hole locations.
2. place the stand in the desired location.
3. reach into the stand from above and mark
the position of the four holes you drilled in
Step 1 onto the shop floor.
4. move the stand, then install mounting hard-
ware into the floor using the method that best
fits your specific application.
5. place the stand over the mounting hardware,
and secure it according to the mounting hard-
ware manufacturer's specifications.
NOTICE
We strongly recommend securing your
machine to the floor if it is hardwired to the
power source. Consult with your electrician
to ensure compliance with local codes.