Grizzly 12" Cold Cut Saw G0682 - Manual (Page 25)

g0682 12" Cold Cut saw (mfg. since 12/10)
-23-
5. rotate the quick release lever counterclock-
wise to clamp the workpiece. between cuts,
rotate the lever clockwise to release the
workpiece, then counterclockwise again to
re-clamp it (
figure 31).
Work Stop
use the work stop to perform consistent length
cuts.
To use the work stop:
1. disCoNNeCt saW From poWer!
2. loosen the work stop hex bolt (figure 32).
Note: An alternative method for using the
quick release lever is to rotate the lever
downward prior to clamping the workpiece.
With the lever in this position, fully clamp
the workpiece using the vise handwheel.
To release the workpiece, rotate the lever
clockwise to the up position. The method you
practice is a matter of personal preference.
3. lower the blade as far as it will go.
4. measure from the side of the blade to the
work stop. slide the work stop until the dis-
tance between the blade and the work stop is
equal to the desired length of the piece being
cut, then tighten the hex bolt (
figure 33).
5. before making a cut, slide the stock until it is
against the work stop. Clamp the workpiece
in the vise, then proceed with the cut. repeat
this process before each new cut for consis-
tent-length cuts.
figure 33. measuring length of cut.
blade
tape measure
Work stop
figure 32. Work stop adjustment.
Work stop
hex bolt
figure 31. Quick release lever positions.
Clamped
released