Grizzly 12" Cold Cut Saw G0682 - Manual (Page 18)

-16-
g0682 12" Cold Cut saw (mfg. since 12/10)
3. attach the rear panel to the stand with the
remaining hex bolts, nuts, and (12) 8mm flat
washers.
Note: If you plan to mount your machine
stand to the floor, do so now (see
Mounting
to Shop Floor on Page 14), then return
to
Step 4, below, to mount the machine to
the stand. Otherwise, continue with Step 4,
below.
4. place the saw onto the stand and secure it
with the four m8-1.25 X 35 hex bolts and flat
washers (
figure 12).
figure 12. mounting saw onto stand.
saw base
stand
hex bolt
5. attach the handle by threading it into the
gearbox head, then tightening the jam nut, as
shown in
figure 13.
figure 13. installing handle.
handle
gearbox head
Jam Nut
7. Connect the support roller to the machine
base by removing the two hex bolts, align-
ing the bracket over the holes, as shown in
figure 15, then re-installing the hex bolts.
before fully tightening the hex bolts, use a
straightedge to make sure the roller is even
with the vise table.
figure 15. support roller.
machine base
hex bolts
support roller
6. Connect the handle switch plug to the control
box by aligning the plug with the socket, then
threading the lock collar (
figure 14).
figure 14. Connecting switch plug.
socket
switch plug
lock Collar