Grizzly 12" Cold Cut Saw G0682 - Manual (Page 20)

-18-
g0682 12" Cold Cut saw (mfg. since 12/10)
once the assembly is complete, test run your
machine to make sure it runs properly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on page 35. if you still cannot
remedy a problem, contact our tech support at
(570) 546-9663 for assistance.
To test run the machine:
1. make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2. verify that there is oil in the gearbox by
checking the sight glass.
—if oil is seen in the sight glass, no further
action is required. Continue to Step 3.
—if no oil is seen in the sight glass, see
Gearbox Oil on page 34.
3. make sure all tools and objects used during
assembly are cleared from the machine, then
connect the machine to the power source.
4. lift the red stop button and press the green
button to turn the machine ON. move the
high/low speed switch to the high position,
then press the trigger switch on the handle.
Test Run
5. listen to and watch for abnormal noises or
actions. the machine should run smoothly
with little or no vibration or rubbing noises.
— strange or unusual noises must be inves-
tigated and corrected before operating the
machine further. always disconnect the
machine from power when investigating or
correcting potential problems.
6. verify that the motor is turning the correct
direction. the blade should rotate so that the
front portion of the blade moves downward.
—if the blade does not turn the correct direc-
tion, stop the machine, shut off the power
source, then swap any two of the three
power wires that connect to the machine.
7. turn the machine OFF.