MiTAC TYAN S7012 - Manual (Page 31)

31
http://www.tyan.com
2.11 – Installing I/O Shield
Before you connect external devices, look into your motherboard package and take
out the I/O shield. Follow the following instructions to install the I/O shield to your
rear panel.
1. Preparation
9
flat-head screw driver x 1
9
long nose pliers x 1
9
protective gloves x 1
9
I/O shield x 1
2. Caution
Warning: To reduce the risk of personal injury, always wear gloves
when handling the I/O shield.
Note that each I/O port has its breaking point which may be not in the same
direction. Use the pliers, not your fingers, to grasp and turn the cap towards the
breaking point to twist it off the shield.
3. Installation
Step 1.
Use the screw driver to push open the I/O
port cap.
Step 2.
Use the pliers to grasp and twist the I/O
port cap off the shield.
Step 3.
Repeat Step 1 & 2 to remove the I/O caps
in accordance with your rear I/O
configuration and then attach the I/O
shield to the rear panel.