MiTAC TYAN S7012 - Manual (Page 45)

45
http://www.tyan.com
3.2.3 Super IO Configuration Sub-Menu
You can use this screen to select options for the Super I/O settings. Use the up
and down arrow (З/И) keys to select an item. Use the Plus and Minus (+/-) keys to
change the value of the selected option
BIOS Setup Utility
Main Advanced PCI/PnP Boot Security Chipset Exit
Configure Win627DHG Super IO Chipset
Serial Port1 Address
Serial Port2 Address
Watchdog Mode
Chassis Intrusion detection
[3F8/IRQ4]
[2F8/IRQ3]
[Disabled]
[Disabled]
Allows BIOS to select
Serial Port1 Base
Address.
←
→ Select Screen
↑↓ Select Item
+/- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Feature Option Description
Configure Win627DHG Super IO Chipset
3F8 IRQ4
3E8 IRQ4
2E8 IRQ3
2F8 IRQ3
Serial Port1 Address
Disabled
Allow BIOS to select Serial Port1 Base
Addresses.
3F8 IRQ4
3E8 IRQ4
2E8 IRQ3
2F8 IRQ3
Serial Port2 Address
Disabled
Allow BIOS to select Serial Port2 Base
Addresses.
Disabled
POST
OS
Watchdog Mode
Power ON
POST: Watchdog timer counting, start at
Power on, stop at OS Boot
OS: Start at OS Boot
Power on: Start at power on
Disabled
Chassis Intrusion
detection
Enabled
When a chassis open event is detected,
the BIOS will record the event and issue a
warning beep.