Reference epson models emulated, Character size/font matrices, Unsupported control codes – Mustek PP3000 User Manual
Page 55: Supported control codes
7 - 5
TM
CHAP. 7
CONTR…
Reference Epson Models Emulated
EPSON TM-300 series.
Character Size/Font Matrices
Refer to page 5 - 4, the 8 CPI character size (5 x 9 pulse 3 full dot mode)
is not applicable for EPSON emulation.
Unsupported Control Codes:
Following EPSON control codes are not supported in PP-300E series due
to hardware difference:
Control Codes
Function
ESC <
Return home
ESC c 3
Select paper sensor(s) for “paper-out” output signal
ESC c 4
Select paper sensor(s) to stop printing
ESC i
Partial cut (leave 1 point)
ESC m
Partial cut (leave 3 points)
ESC r
Select print color
Supported Control Codes:
NOTES:
• Default character spacing for 7 x 9 font is 3 dots, for 5 x 9 is 2 dots. These
values are the minimum settings. In 5 x 9 font, no odd number spacing is
allowed, or it will be automatically decreased.
‚ Font select: 1
⇒
7 x 9; 0
⇒
5 x 9.
ƒ 7 x 9 font is recommended in defining user-define characters. When original 9
x 9 characters are downloaded under 5 x 9 font printing mode, the characters
will be automatically transferred to 5 x 9 by removing the half-dot bits.
„ Internatioal character n in hex code:
<00>
⇒
USA,
<01>
⇒
France,
<02>
⇒
Germany,
<03>
⇒
England,
<04>
⇒
Denmark,
<05>
⇒
Sweden,
<06>
⇒
Italy,
<07>
⇒
Spain,
<08>
⇒
Japan,
<09>
⇒
Norway,
<0A>
⇒
Denmark II,
<0B>
⇒
Croatia.
… Character table n in hex code:
<00>
⇒
USA&Europe, <01>
⇒
IBM 1,
<02>
⇒
IBM 2,
<03>
⇒
JAPAN.