Mustek PP3000 - Manual (Page 70)

A - 14
TM
APP. A
STAR …
CODES (HEX/CONTROL) : 1B 4B n1 00 / <ESC> “K” n1 <0>
1B H 4BH n1 00 m1 m2
…
/ <ESC> “K” n1 <0> m1 m2
…
FUNCTION : 8 dot single density bit image
DEFINITION RANGE : 1
≤ n1 ≤ 200
DETAIL DESCRIPTION :
This code executes 8 dot bit image print
determined by “n1”. The total number of bit image data bytes in one line is equal
to n1. The printer ignores any data bytes over the specified amount allowed in
one line. When the bit image print is finished the printer automatically returns to
the character mode. The relationship of the image data byte and the pin position
of the print head is as following, where the print pin # starts count at 1 from top
of the print head (the lowest pin # 9 is not used):
bit # of m1 , m2, etc.
8
(MSB)
7 6 5 4 3 2 1
(LSB)
engage print pin # 1 2 3 4 5 6 7 8
CODES (HEX/CONTROL) : 1B 4C n1 n2 / <ESC> “L” n1 n2
1B 4C n1 n2 m1 m2
…
/ <ESC> “L” n1 n2 m1 m2
…
FUNCTION : 8 dot double density bit image
DEFINITION RANGE :
1
≤ n1 + 256 x n2 ≤ 400
APPLICATION LIMIT :
1. For double density bit image printing, dots cannot be printed overlapping
each other in the horizontal direction.
2. When printing one graphic image of a minimum of two lines with <ESC> “K”
or <ESC> “L”, feed the paper a minimum of one line before printing so that
the line spacing becomes identical between the lines.
DETAIL DESCRIPTION : This code executes double density bit image
printing (half dot printing) determined by n1 and n2. The total number of bit
image data bytes in one line is equal to n1 + n2 x 256. Refer to <ESC> “K” as to
the relation between the dot position and the bit number. The printer ignores any
data bytes over the specified amount allowed in one line. The printer does not
print adjacent dots. When the bit image printing is finished, the printer
automatically returns to the character mode.