Monessen Hearth CSDV40SLP - Manual (Page 27)

58D6056
27
CSDV Series Direct Vent Gas Stove
pLACE CSDV30 LOGS IN FIREBOx
Figure 38
1. Carefully remove logs from wrapping.
2. Open front door of firebox.
3. Place rear log (#1) on rear log pin.
4. Place left base log (#2) on the two pins against left side
of firebox.
5. Place right base log (#3) on the two pins against right
side of firebox.
6. Place top left log (#4) on left base log. Line up the notch
in the bottom of the top log with the locator pins on the
bottom log.
7. Place top right log (#5) on right base log. Line up the
notch in the bottom of the top log with the locator pins
on the bottom log.
LOG pLACEmENT
PIL OT
OFF
REMO TE C ON TROL
LG815
CSDV30 logs
Top Left Log #4
Top Right Log #5
Right Base
Log #3
Rear Log
#1
Left Base
Log #2
Pins
Pins
LG816
Figure 38 -
Place CSDV30 Logs
pLACE LOGS AND ROCK WOOL
(EmBER mATERIAL) IN FIREBOx
Break up rock wool (ember material) into dime-sized
pieces. Fluff up rock wool. Place rock wool evenly across
the front of the burner surface. Do not block any areas
around the perimeter of the burner, as these are the areas
that supply the needed air for secondary combustion. Do
not cover the screen on the rear half of the burner as this
area allows for air to enter under the front logs. Do not
place rock wool under logs. Figure 39
NOTE: Do not exceed one (1) layer of rock wool
overage. Do not place rock wool on rear of burner.
PIL OT
OFF
REMO
TE C ONTR OL
LG816
CSDV30 rockwool
Rock Wool
LG817
Figure 39 -
Place CSDV30 Rock Wool