Master Lock E72 User Manual
Page 19
Lock Upgrade
Function 20
Page 28
IF ERROR ON ENTRY OR NO ENTRY IN 5 SECONDS, LOCK WILL TIME-OUT. BEGIN AT STEP 1.
Valid User Code
Level: Master
This function is used to upgrade the memory of your E72. Here are the steps.
1. Obtain the lock serial number.
The serial number is printed on the exterior backplate of the E72.
Or, using the IDT, the serial number appears on the IDT display, as well as, on the header of the
audit trail (Func. 15).
2. Obtain upgrade code.
Call SDC at 1-805-494-0622 with your serial number. An SDC customer service representative will
take your order and fax back/call back with your upgrade code. Please retain your upgrade code for
your records.
OR
Call your local SDC distributor with your serial number. They will obtain your upgrade code and fax
back/call back with your upgrade code. Please retain your upgrade code for your records.
3. Install upgrade number into the E72.
Using this function, enter your upgrade code from the back of your upgrade card.
Note: By upgrading the E72’s memory, the lock will reset to the factory defaults. All
information currently stored in the memory will be lost. It is recommended before updating your
memory, use the IDT to download an audit trail (Func. 15). This will allow you to use the information
later to update the E72’s memory. After the upgrade is complete, the E72 is re-initialized and the
Manufacturer Supplied
ENTRIES
VISUAL / AUDIO
Function Number
0
*
2
Note
UPGRADES are PERMANENT even if lock is reset.
LOCK SERIAL NUMBER REQUIRED.
LOCK CANNOT be DOWNGRADED.
ENTER “#” to return to FUNCTION NUMBER (Step 2) and continue programming.
#
*
See Note
Exit
*
Enter Upgrade Number
1.
2.
3.
4.
Function 35
IR Interrupt
Page 29
IF ERROR ON ENTRY OR NO ENTRY IN 5 SECONDS, LOCK WILL TIME-OUT. BEGIN AT STEP 1.
Valid Code
Select One:
(0) DISABLE
(1) ENABLE
Level: Grand Master
This function PREVENTS IR transmission between the lock and the IDT Upload/Download device for extra
security.
To DISABLE the IR Interrupt, enter "0".
To ENABLE the IR Interrupt, enter "1".
Note
The DEFAULT for this function is “0” DISABLED.
ENTER “#” to return to FUNCTION NUMBER (Step 2) and continue programming.
0
*
1
*
ENTRIES
VISUAL / AUDIO
Function Number
5
3
*
#
See Note
Exit
*
1.
2.
3.
4.