Mocomtech CIM-550 - Manual (Page 98)

CiM-550 IP Enabled Satellite Modem Rev. 2
Remote Control CD/CIM550.IOM
72
Parameter
Type Command
(Instruction
Code and
qualifier)
Arguments for
Command or
Response to
Query
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
Response to Command
(target to controller)
Query
(Instruction
Code and
qualifier)
Response to
query
(target to
controller)
B= AUPC enable - same as AUP= (1 byte)
Y = AUPC setup - same as APP= (6 bytes)
W =Stats log interval- same as SSI (1 byte),
Example:
MGC=074.56780064.0001720112.720082.65430
128.0002320116109.81211100000102361115.659
Config Store CST= 1 byte,
numerical, 0 to
9
Forces the unit to store the current modem
configuration in Configuration Memory location
defined by the one byte argument (0 to 9).
Example CST=4 (Store current config in location 4)
WARNING: Use with caution! If the location
already contains data it will be automatically
overwritten. If in doubt, query the location first.
CST= (message ok)
CST? (received ok, but
invalid arguments found)
CST?n, where
n is 0 to 9
CST?0, or
CST?1, or
CST?2, or
CST?3, or
CST?4, or
CST?5, or
CST?6, or
CST?7, or
CST?8, or
CST?9 Return the
same format as
the MGC with
the form:
CST= for a
valid config, and
CST* where no
valid config is
found in that n
Config Load CLD= 1 byte,
numerical, 0 to
9
Command only.
Forces the unit to retrieve the Configuration
Memory location defined by the one byte argument
(0 to 9). and to re-program the unit with that stored
configuration.
CLD= (message ok)
CLD? (message received
ok, but an invalid argument
was found,
CST* (message ok, but the
requested location does not
contain a valid configuration)
N/A N/A
Re-center
Buffer
RCB= None Command only.
Forces the unit to re-center the receive
plesiochronous/doppler buffer.
RCB= (message ok) N/A N/A