Mocomtech CIM-550 - Manual (Page 99)

CiM-550 IP Enabled Satellite Modem Rev. 2
Remote Control CD/CIM550.IOM
73
Parameter
Type Command
(Instruction
Code and
qualifier)
Arguments for
Command or
Response to
Query
Description of arguments
(note that all arguments are ASCII numeric
codes, that is, ASCII codes between 48 and 57)
Response to Command
(target to controller)
Query
(Instruction
Code and
qualifier)
Response to
query
(target to
controller)
This command takes no arguments.
Force 1:1
Switch
FSW= None Command only.
Forces the unit to toggle the Unit Fail relay to the
‘fail’ state for approx 500ms. If the unit is a 1:1 pair,
and it is currently the ‘On Line’ unit, this will force a
switchover, so the unit will then be in ‘Standby’
mode. The command is always executed by the
unit, regardless of whether it is stand-alone, in a
1:1 pair, or part of a 1:N system.
This command takes no arguments.
FSW= (message ok) N/A N/A
10dB
attenuator
set ATS= 1 byte, value of
0 or 1
FACTORY USE ONLY
Modulator output 10dB attenuator setting, where
0 = no attenuation
1 = 10 dB attenuation
Example: ATS=0
(Used for power-level calibration) ATS= (message ok)
ATS? (received ok, but
invalid arguments found)
ATS* (message ok, but not
permitted in current mode)
ATS? ATS=n
where n is 0
or 1
Power level
DAC set
DAC= 4 bytes,
numerical
FACTORY USE ONLY
Modulator power output DAC setting. An argument
between 0000 and 4095 is required
Example: DAC=1287
(Used for power-level calibration) DAC= (message ok)
DAC? (received ok, but
invalid arguments found)
DAC* (message ok, but not
permitted in current mode)
DAC? DAC=xxxx
where xxxx
is a value
between 0000
and 4095
Write
EEPROM
Value EWR= 7 bytes Command only. FACTORY USE ONLY
A command in the form ddd,aaa, where ddd is a
single byte data value between 0 and 255, and aaa
is a starting address (in the range 0 - 127) within
the serial EEPROM, where the data is to be
written.
Example: EWR=127,104 means write the value
EWR= (message ok)
EWR? (received ok,
but invalid arguments found)
EWR* (message ok, but not
permitted in current mode)
N/A N/A