Motorola SABER RVN4002K - Manual (Page 15)

III. HARDWARE INSTALLATION
A. Host Computer And Options Required
The following section provides the hardware and software requirements needed to run the
SABER Radio Service Software .
Computer:
IBM PC or CONVERTIBLE
IBM-XT
IBM-XT/286
IBM-AT
IBM-PS/2: Models 25, 30, 50, 60, 70, or 80
Memory Required:
At least 640k bytes of RAM.
Operating System:
The software requires the DOS Version 3.1 or later to run this package.
Disk Storage:
The software will be available on both 3 1/2" and 5 1/4" (RVN-4002H) media and must be
installed onto a hard disk drive. However, you can also store the data files on either 3 1/2"
and 5 1/4" disks.
Communication Card:
A serial port is also required if personality files are to be read from or written to a radio. The
serial port must be compatible with the IBM asynchronous communications adapter.
Printer:
A parallel interface IBM compatible printer is required if you plan to use the print facilities of
the software.
Monitor:
A monochrome or color monitor compatible with the IBM monochrome display or IBM
CGA/EGA adapter is required.
9 Hardware Installation