Motorola SABER RVN4002K - Manual (Page 36)

C. Align Channel Parameters
In order to align the channel level parameters, squelch, VCO Modulation, Reference Modulation,
and Battery Save Enable, select the ALIGN CHANNEL PARAMETERS item in the ALIGN menu.
These parameters are called channel level parameters because they have to be adjusted on
every channel as opposed to the radio level parameters which apply to all the channels in the
radio. Once the ALIGN CHANNEL menu has been selected, the system will display the screen
shown in Figure 11. At the bottom of the screen the current zone/channel combination being
aligned will be displayed. Merely select the next zone/channel on the radio to be aligned and the
screen will update the display.
Figure 11. Align Channel Menu
Note that on certain alignment procedures, the last step states "Reprogram radio," this means
AFTER all alignment is completely finished, you must reprogram the radio. You do not have to
reprogram the radio after each parameter is aligned.
Function Key Descriptions:
F2 Copy to all - This function key will copy a particular alignment parameter value to all
the channels. For example, If VCO for the current channel is $1F, pressing F2 will set
VCO to $1F in all channels.
F3 Copy to zone - This function key will copy the particular alignment parameter value to
all the channels in the current zone.
MOTOROLA Radio Service Software
SABER Model
Ver. R05.00.00 Use UP / DWN Arrows to Change Value.
PGUP /PGDN to Change Rapidly.
Squelch Level
VCO Modulation
Reference Modulation
Battery Save Enable
F1
HELP
F2
COPY
TO ALL
F3
COPY TO
ZONE
F4 F5
PRINT
SCREEN
F6
COPY ALL
TO ALL
F7 F8 F9 F10
EXIT
Main.Align.Channel
ALIGN CHANNEL PARAMETERS
00
00
00
00
0 10 20 30 40 50 60 70 80 90 100%
Rx: 150.00 MHz
Sq.: 167.9 6Z Zone01: Channel 001
Sq.: NOT DETECTED Tx: 150.000 MHz
Sq.: 167.9 6Z
R07.01.00
30 Servicing the Radio