Marmitek EasyTouch35 - Manual (Page 9)

9 EASYTOUCH 35
7. Display will show the Code Setup Screen. Enter the 3 digits
of the Device Code from the Library Code Tables. For a
valid Code, the LED blinks off after the last digit is entered.
For an invalid Code, the LED will flash rapidly three times
before going off. In both cases, the display will return to
the Main Setup Screen.
8. Press and release the Touchscreen "EXIT" key to return to
normal operation.
9. Point the remote in the direction of your TV and press the
POWER key. Your device should turn off. Check other
functions (for example for a VCR: FF or REW etc.). If certain
functions are not responding this indicates that the entered
code is not the correct one. In that case repeat the above
procedure with the next corresponding code of your brand.
10.Direct Library Code entry now complete
11. Repeat this procedure for the other appliance you want to control (TV, VCR, DVD,
SAT, CD, CBL, AUDIO and Marmitek X-10 Home Automation)
7 Programming using Brand Search Method
It is possible to search for your appliance’s code by entering the brand of the appliance
you wish to control.
1. Make sure your appliance is switched on.
If not switch it on manually
2. Press and hold Setup key until the LED remains on
(occurring after approximately 2-3 seconds) and display
shows Main Setup Screen.
3. Release Setup key.
4. Press and release the
Touchscreen "CODE" Key.
5. Display will show the Mode
Setup Screen. Press and release
desired Mode key (TV, VCR,
SAT, etc.) on the rubber
keypad. Note the Brand Search
Method is not available for
CD/Audio appliance.
ENGLISH
easytouch35_manual ok 6/17/03 10:30 AM Page 9