Miele G 803 - Manual (Page 20)

Salt indicator.
When the salt reservoir is empty, the
“Salt-PC” indicator lights, indicating that
it needs to be refilled with reactivation
salt.
After the reservoir has been filled, the
water softener is automatically reacti-
vated the next time the dishwasher is
started. The “Softener” indicator will
light during this process.
Note:
If your water is very soft (below
4 gr/gal), the salt indicator light will
stay on. The reservoir should not be
filled with salt. The indicator will remain
lit and should be disregarded or
bypassed.
The “Salt-PC” indicator has also been
designed so that future program up-
dates can be entered into the dish-
washer. See “After Sales Service”.
Bypassing the Salt indicator.
In order to bypass the salt indicator
light, you will need a screwdriver and
needle nose pliers.
^ Remove the salt reservoir cap.
Looking into the salt reservoir, you will
see the top of the float chamber on the
right hand side
b
.
^ Using a screwdriver, carefully pivot
the float chamber towards the center
of the reservoir.
^ Using the needle nose pliers, pull the
cap
c
off of the float chamber, and
remove the float
d
.
^ Replace the float chamber cap, push
the chamber back into its upright po-
sition, and replace the salt reservoir
cap. The indicator should not light.
Before using for the first time
20