Mark Levinson N32 - Manual (Page 56)

4-12
Controls and Modes Mark Levinson
4. Connect the front left and right output connectors on the pro-
cessor to the desired stereo input connector on the Nº32.
For best performance, use balanced connections whenever
possible.
5. Connect the desired main output connectors on the Nº32 to
the appropriate input connectors on the power amplifier.
Caution!
Before activating SSP mode, set the associated surround sound
processor volume control to a reasonable level to prevent send-
ing dangerous signal levels to the associated loudspeakers.
6. Rotate the select knob or press the select / buttons to select
the Nº32 input for which the stereo input connector selected in
step 4 is assigned.
The front panel display indicates the name and volume level of
the selected input.
7. Press and hold the setup button until the Name parameter for
the selected input displays on the front panel.
The front panel setup LED lights when the setup menu is
displayed.
8. Press the enter button to select the Name parameter and access
the custom names list.
The current input name blinks to indicate that a new input
name can be selected from the custom names list.
9. Rotate the volume knob or press the volume ± buttons to scroll
through all custom input names included on the custom names
list until the SSP name displays on the front panel.
10. When the SSP name appears, press the enter button to select
this name and activate SSP mode.
The following two events happen:
a. The SAVING DATA message displays on the front panel to
indicate that the SSP name is being saved.
b. Then the SSP ____OFF message displays, indicating that the
SSP mode has been selected, but is disabled.
This is by design, so that no potentially damaging signals pass
through unintentionally. Before activating SSP mode, check the
surround sound processor volume control mode and reduce the
level if necessary.