Mark Levinson N32 - Manual (Page 65)

5-1
Troubleshooting
Incorrect operation is sometimes mistaken for malfunction. If prob-
lems occur, see this section for troubleshooting information. If
problems persist, contact your Mark Levinson dealer.
No Power 1. Examine the power cord to ensure that it is connected to both
the ~ac mains connector and an electrical outlet.
2. Make sure the Nº32 is powered on with the power button.
3. Make sure the Nº32 is not in standby. The controller front panel
standby and preamplifier LEDs blink in unison when the Nº32
is in standby. The standby LED lights red when the Nº32 is not
in standby.
4. Make sure display intensity has not been set to off (0%), deacti-
vating the front panel display.
5. Examine the electrical circuit breaker to ensure that power is
being supplied to the electrical outlet to which the Nº32 is con-
nected.
No Remote Control
Operation
1. Eliminate obstructions between the remote control IR transmit-
ter and the front panel display IR receiver/transmitter.
2. Make sure the IR input connector is not being used.
3. Make sure the remote control IR transmitter LED lights when
remote control buttons are pressed, indicating that IR signals
are being transmitted.
4. Make sure the remote control is positioned within 17 feet (5m)
of the front panel display IR receiver/transmitter. If the Nº32 is
placed inside a glass cabinet, tinted glass will reduce the remote
control range.
5. Make sure the remote control signal is being received at the
front panel display IR receiver/transmitter at a reasonable angle.
6. Make sure the front panel display IR receiver/transmitter is not
exposed to strong sunlight, halogen light, or fluorescent light.
This can cause IR reception to become unreliable.
7. Replace the remote control batteries.
Troubleshooting & Maintaining
5