Mark Levinson N32 - Manual (Page 68)

5-4
Troubleshooting & Maintaining Mark Levinson
Restoring Factory-default
Settings
Performing this procedure restores all parameters and user-defined
controls to their factory-default settings. Before performing this
procedure, it is recommended to record all custom settings on the
“Installation Worksheet” on page A-6.
To restore factory-default settings:
1. Make sure the Nº32 and all associated components are powered
off.
2. Press and hold the front panel record out and setup buttons.
Remote control buttons cannot be used to restore factory-
default settings.
3. Still holding the record out and setup buttons, press and
release the power button to power on the Nº32.
The CLEAR SETUP? message displays on the front panel.
4. To restore factory-default settings, continue holding the record
out and setup buttons for about 10 seconds. The FACTORY
SETUP RESTORED message blinks on the front panel display
The current software version number will appear on the front
panel display, and the Nº32 will enter standby.
To cancel restoration of factory-default settings, release the
record out and setup buttons before the FACTORY SETUP
RESTORED message appears on the front panel display. The
CLEAR and CANCELLED messages will blink on the front panel
display as shown below to indicate that restoration of factory-
default settings has been cancelled.
5. Power on all associated components that were powered off in
step 1.
Care & Maintenance
The Nº32 requires routine care and maintenance to ensure optimal
performance. The bulleted items in this section indicate mainte-
nance procedures that should be performed on a regular basis.
Note
Failure to perform the maintenance procedures included in this section
may void the manufacturer’s warranty and/or standard repair policies.