Micro Innovations M000174-19 - Manual (Page 15)

Windows CE Ethernet
M000174-19 15
2 E
THERNET
The Ethernet interface is implemented in compliance with the IEEE 802.3 (10/100BASE-T) standard.
The network is implemented with shielded twisted-pair cables and shielded RJ45 plugs. The devices
networked with the MICRO PANEL must also be provided with shielded connections. The twisted-pair
cable selected for use in Ethernet networks must comply with the cable specifications with regard to
cable length and transmission speed. See also specification to EIA/TIA 568 TSB-36.
The cables of the Ethernet interface must be laid separately from the low-voltage cables.
2.1 A CCESS TO PC
Network name
Each panel is given a unique network name in order to avoid conflicts within a network. When the
panel is started, the name is displayed together with its relevant IP address. A device name must only
occur once in the same network.
Caution:
With Windows CE it is only possible to access external resources (drives/directories/printers) via
names and not via IP addresses. Further information is provided in chapters
Name resolution in
Windows networks , Network access procedure and Network test .
User name / Password / Domain:
The MICRO PANEL has the following default settings:
User name: MI_PANEL
Password: No password defined
Domain: No domain defined
The settings can be modified with the Owner program.
Note:
The user name and password must always be given to access a PC!
Examples of external access:
Direct access to the computer resources is possible or via the local directory
\Network\«EnableName». All computer resources associated with the net use command are listed in
the directory \NETWORK of the MICRO PANEL. The use of the net use command is described in
chapter
Network access procedure .
Direct access to computer resource: Examples:
\\«Network name of the computer»\«Printer name» \\PC-001\ColorPrinter
\\«Network name of the computer»\«Directory» \\PC-001\transfer
Access via «connected» resources
\Network\«mapped printer name» \Network\HP6940
\Network\«mapped directory name» \Network\pc001
The name of the computer must be specified under «Network name of the computer». IP addresses
are not supported here. Enter the name of the enabled printer under «Printer name».