Micro Innovations M000174-19 - Manual (Page 23)

Windows CE System settings
M000174-19 23
4.3.3 C OMMAND LINE PARAMETERS
The command line call is described in chapter 4.1. The following parameters are supported:
Parameter Description
-id [Time Zone ID]
Set time zone according to the Time Zone ID, e.g. -id 6912
The Date/Time dialog of the Time Zone tab shows the time zone IDE of the
selected time zone.
4.4 S CREEN SETTING (D ISPLAY )
4.4.1 B ACKLIGHT
This program can be used to set the backlight to the
required value. The setting made is stored as persistent
data, i.e. it is retained even after a restart.
The lower values such as 40 and 60 % are «stand by»
values and are not therefore intended for normal operation.
The reduction of the backlight increases the lifespan of the
backlight (tubes).
Note:
The supported percentage values depend on the device
concerned.
Dim Value
This is the dialog to select the appropriate dim value of the
backlight. An activation of the screen saver reduces the
backlight to this dim value. The screen saver is part of the
HMI program.
Use the arrow buttons to set the required dim value and
touch Save to store the value as persistent data.
4.4.2 C ONTRAST
This program is used for setting the screen contrast. The
«Middle» setting is the factory setting. Touch «Save» to
save the selected setting as persistent data, i.e. the value is
retained even after a restart.
Note:
This setting is not required for devices with an active
display (TFT technology) and is therefore not available.