Micro Innovations M000174-19 - Manual (Page 41)

Windows CE Network test
M000174-19 41
5 N
ETWORK TEST
Once you have adjusted the system settings, particularly network settings, first of all check whether
the device can be addressed in the network.
For this connect the device directly to a network connection/hub (patch cable) or directly with a
network cable to your workstation (cross cable).
From the workstation carry out at the MS-DOS entry prompt the «Ping» command with the IP address
set on the device (see example).
The first part of the network test is completed if you receive a response from the device as shown in
the example.
Next carry out the test on the MICRO PANEL in the same way as the network test. The exact
procedure is described in the chapter
Ping .
Only when both network tests have been successfully completed is the network configuration correct
or completed.
For network specialists the following command line programs are available, for further information
refer to the command line help (call the program with parameter «/?», e.g. «ipconfig /?» ):
• ipconfig
• route