Micro Innovations M000174-19 - Manual (Page 31)

Windows CE System settings
M000174-19 31
4.7.4 I NFO
The MAC address of the HMI device is displayed in the Info page. This is a manufacturer-specific and
unique Ethernet connection number of the device.
Note:
The Info tab is not available for XV100 devices. The MAC address can be viewed by double touching
the icon in the network connection in the taskbar.
4.7.5 C OMMAND LINE PARAMETERS
The network settings can either be made using the «IpSetup.exe» program or as described in the
chapter
Command line call . The supported parameters are listed in the following table. All parameters
can be used as required, although only the settings of the used parameters can be changed.
-a [IP address] IP address
-a off Delete IP address or set to 0.0.0.0. DHCP is activated automatically if the
address is set to 0.0.0.0.
-m [Subnet mask] Subnet mask
-m std Subnet mask is set according to the class of the set IP address (see table of
IP classes in chapter
IP Address )
-g [Gateway] Sets the gateway address
-g off Deletes the gateway address
-d [DNS] First DNS address
-d2 [DNS] Second DNS address
-d off Deletes the DNS addresses
-w [WINS] First WINS address
-w2 [WINS] Second WINS address
-w off Deletes the WINS addresses
-speed auto, 10, 100 Sets the network speed to 10M, 100M or automatic. The default setting is
«auto», which causes the device to determine the network speed
automatically. If a fixed speed is set, the «duplex» setting must also be set.
-duplex auto, half, full Sets the «Duplex» mode to «half», «full» or automatic. The default setting is
«auto». The setting must always be activated together with «speed».
-r Device is restarted immediately if the settings are modified.
-c If this option is used, the network settings do not apply to the integrated
Ethernet interface but to an NE2000 compatible network card in the
Compact Flash slot.
-s Status display of the current settings
-? Shows the possible parameters on screen
For example, the following line inside the «Autoexec.bat» file sets the IP address:
START ipsetup.exe –a 192.168.1.1 –m 255.255.0.0 –g off –w off –d off