Minolta PCL6 - Manual (Page 58)

8. Overlay tab
3-26
P
rop
er
ti
es
Se
tt
in
gs
Ch
apte
r 3
(11) Shading
Specify the density of the characters.
Setting range: 5% to 100%
(12) Angle
Specify the angle of the characters with respect to the paper.
• Angle
Default angle fixed by the driver.
Available settings: Horizontal, Diagonal, Vertical,
User Setting
• User Setting If you select “User Setting” from the Angle list, you
can set any desired angle.
Setting range:
-180° to +180° (A – (minus)
value rotates the characters
clockwise, 0 leaves the characters
parallel to the paper, and a +
(plus) value rotates the characters
counterclockwise.)
(13) Position
Specify the position at which you wish to print a watermark.
• Center
The watermark is printed in the center of the paper.
• User Setting You can specify a position by entering numbers in the
Horizontal and Vertical boxes.
Setting values:
Horizontal
-999 to 999 points (in 1-point
steps)
Vertical -999 to 999 points (in 1-point
steps)
(72 points = 1 inch)
TIPS
• Specify the position from the center. The Horizontal positive direction is to the
right, and the Vertical positive direction is upward.
• You can view your settings in the Preview area (1).