Minolta PCL6 - Manual (Page 81)

3. E.C.M. (E.K.C.)
A-15
A
p
p
end
ix
[3] E.C.M. function setting
Use this function to turn E.C.M. on or off and to select whether the machine will
stop when the count limit is reached or the copier will complete the copy job before
stopping when reaching the maximum copy count.
Procedure
1. Touch [4] E.C.M. function setting on the Key operator mode menu screen. Enter
an 8-digit E.C.M. master key code, and then touch [OK] to display the E.C.M.
setting menu screen.
NOTE:
If an invalid E.C.M. master key code is entered, continue by entering the valid
8-digit code.
2. Touch [3] E.C.M. function setting. The E.C.M. function setting screen will be
displayed.
3. Touch [E.C.M. On] to activate E.C.M. or touch [E.C.M. Off] to deactivate
E.C.M.
The selected key will be highlighted.
4. Touch [Immediately] to stop the machine at once when the copy limit is reached.
In this case, copy conditions selected for the current job will be cleared. To
continue the job using the same user password, change the copy limit of the
password or clear the copy count.
Touch [After job] to stop the machine after the current job is completed when
the copy limit is reached.
Touch [Warning] to only display a warning message when the copy limit is
reached.
The selected key will be highlighted.
5. Touch [OK] to complete the setting and return to the E.C.M. setting menu
screen.
6. If other E.C.M. setting changes are required, touch the desired key from [1] to
[3].
ECM Setting Menu Screen ECM Function Setting Screen
C4027P221CA C4027P233CA