Marantz MV8300_U1B - Manual (Page 23)

EN
23
Selecting monitor sound
— Audio Monitor
You can select the desired monitor sound.
While playing back a tape on which stereo sound or SAP
sound is recorded, press A. MONITOR on the Remote.
Each time you press the button, sound changes as follows:
S-VHS/VHS
L R : Normally select this.
Hi-Fi sound is played back.
L: Sound on the left Hi-Fi channel is played
back.
R : Sound on the right Hi-Fi channel is played
back.
NORMAL: Sound on the normal track is played back.
MIX:
Both sounds on the Hi-Fi track and
normal track are mixed and played back.
D-VHS
L R : Normally select this.
L:
Sound on the left channel is played back.
R : Sound on the right channel is played back.
NOTES:
● The above indication appears when “SUPERIMPOSE” is set to
“ON” (
੬ pg. 57), though the monitor sound changes in
sequence.
● If the tape being played back has no Hi-Fi sound track, the
normal sound track will be heard regardless of this setting.
C
NORMAL MIX
L R L R
D
L R L R
Adjusting tracking condition
— Tracking Adjustments
Automatic tracking adjustment
This VCR automatically adjusts the tracking condition.
Whenever you insert a tape and start playback,
automatic tracking starts working and continuously
analyzes the signal to enable optimum picture quality
during playback.
Manual tracking adjustment
If automatic tracking cannot eliminate noises well during
playback, use the manual tracking following the
procedures below.
● You can also use the manual tracking during slow
motion playback ( ੬ pg. 33). During slow motion
playback, simply press CHANNEL + or – on the VCR
(or TV/VCR CH + or – on the Remote) to adjust
tracking.
1
Activate manual tracking
Press CHANNEL + and – on the front panel at the
same time during playback.
2
Eliminate the noises on the TV screen
Press CHANNEL + or –.
● Press it briefly for a fine adjustment, or press and
hold for a coarse adjustment. Watch the screen
and continue adjustment until optimum picture
and sound quality are achieved.
● To reactivate automatic tracking, press CHANNEL
+ and – on the front panel at the same time. The
automatic tracking becomes active again.
HM-DH40000U-EN21-33 1/22/3, 4:37 PM 23