Marantz MV8300_U1B - Manual (Page 55)

EN
55
* The default setting is bold in the table below.
Up to four audio signal channels can be input from a DV camcorder
through the DV IN connector (i.LINK). This VCR allows you to select
and record two of these channels. This setting is used to specify which
two channels to record.
When there are four DV audio channels (32kHz):
AUDIO1: Records the two channels (L/R) of DV AUDIO 1.
AUDIO2: Records the two channels (L/R) of DV AUDIO 2.
1+2MIX: Mixes and records both DV AUDIO 1 and 2.
When there are two DV audio channels (48kHz):
Because there are only two channels, those two channels are recorded
regardless of the DV sound setting.
Ⅵ DV AUDIO REC
AUDIO1
AUDIO2
1+2MIX
Ⅵ OPTICAL OUT
Dolby D
2CH-PCM
STREAM
Audio settings [AUDIO FUNCTION]
S400
DV IN
D THEATER
REGION 1
i.LINK IN/OUT
DIGITAL OUT OPTICAL PCM/DOLBY DIGITAL R
Y
L
P B /C B
VIDEO
P R /C R
S VIDEO S VIDEO
AUDIO
IN(L-1)
IN(L-2)
REMOTE PAUSE/ AV COMPULINK
CABLE BOX ANTENNA
ANTENNA
OUT
IN
VHF/UHF
R L VIDEO AUDIO
OUT IN
COMPONENT
VIDEO OUT
This VCR can send the Dolby Digital bitstream or PCM Audio to external
devices.
When you play back a tape including the Dolby Digital bitstream, and if
you have a device equipped with Dolby Digital decoder, set this
function to “Dolby D”.
If not, set this function to “2CH-PCM”.
“STREAM” will be used when playing back and receiving a audio signals
in other new formats.
When this function is set to “ON”;
● If a SAP program is received, the SAP audio is recorded on both the
normal and Hi-Fi tracks. The main audio is not recorded.
● If a non-SAP program is received, the main audio is recorded on both
the Hi-Fi and normal tracks.
When this function is set to “OFF”, the SAP audio cannot be recorded.
Ⅵ 2ND AUDIO REC
ON
OFF
CONTINUED ON NEXT PAGE \
Ⅵ STD AUDIO REC MODE
STANDARD
PCM&STANDARD
You can select the audio format when you record a program or
analog signal from connected devices in STD mode. When this
function is set to “PCM&STANDARD”, you can obtain high-quality
audio sound.
STANDARD: Select this when the picture quality is important
and when you record in MP2 format.
PCM&STANDARD: Select this when the sound quality is important.
When you record the analog signals or DV signals
from the camcorder in STD mode, PCM audio is
also recorded in addition to MP2 audio. In HS
mode, PCM audio is automatically recorded.
Amplifier equipped
with Dolby Digital
decoder
Note for connection:
Remove the protection
cap from the cable.
This VCR
HM-DH40000U-EN53-63 2/4/3, 4:15 PM 55