Marantz MV8300_U1B - Manual (Page 74)

74
EN TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Connect the Controller correctly
(
੬
pg. 18).
After confirming your DBS receiver’s
input channel number, re-access the
DBS Receiver Set screen and select
the correct number (
੬
pg. 19).
Set the correct DBS receiver brand
code (
੬
pg. 20).
Make sure the power is on before
timer recording starts.
Set “INPUT CH” to “OFF”
(
੬
pg. 16, 19).
Re-perform the Changing VCR Plus+
Setting procedure (
੬
pg. 36).
Wait until a space in memory clears,
or cancel unnecessary program
information (
੬
pg. 40).
SYMPTOM
7. Satellite channels are not
automatically switched during timer
recording.
8. Timer recording begins as
scheduled, but the channel is
always incorrect.
9. You moved, and now VCR Plus+
system does not work properly.
10.“PROGRAM FULL” is displayed on
the screen.
POSSIBLE CAUSE
● The Controller is not properly
connected to the VCR.
● The input channel selected on the
DBS Receiver Set screen is incorrect.
● The VCR is not set correctly to control
the DBS receiver.
● The DBS receiver is turned off.
● Even though you do not use an
external cable box or DBS receiver,
on the Cable Set Up screen or DBS
Receiver Set screen, “INPUT CH” is
set to “ON”.
● The receivable stations in the new
area are received on different
channels than those in the previous
area.
● All 24 programs of the VCR’s timer
memory are used.
TIMER RECORDING
HM-DH40000U-EN72-91 1/22/3, 5:44 PM 74