Motorola WR850G - Manual (Page 21)

SECTION 2 INSTALLATION
2-6 SECTION 2, INSTALLATION
Electrical Connection to Router
Your router does not have an On/Off power switch and therefore will
only be powered on by plugging in the power adapter:
Reset
Power LAN
To power
supply
1 Connect the power adapter to the router’s Power port, found on
the back of the unit.
2 Then plug the power adapter into a grounded and surge
protected power outlet.
! The Power LED on the front panel lights green when
connected properly.
Easy Software Setup
Run the Installation Wizard program from the supplied CD-ROM to
quickly setup your network. Once your network is up and running,
refer to Section 3:Configuration for advanced configuration.
Manual Software Setup
If you’d prefer to manually setup your network, use this section to
configure it. This section details the physical connection of the router
to your network as well as the configuration needed by your PC.
To set up your wireless network:
! Physically connect and power on the router
! Configure your PCs
! Enter Wireless Security settings