Motorola WR850G - Manual (Page 69)

CONFIGURATION SECTION 3
SECTION 3, CONFIGURATION 3-35
2 Outgoing Protocol: From the drop down box, select either TCP or
UDP.
3 Outgoing Port: Enter the From and To ranges (0 to 65535) for
your application.
4 Trigger Inbound Protocol: From the drop down box, select either
TCP or UDP.
5 Incoming Port: Enter continuous value(s) (0 to 65535), separated
by dashes, for your application. You can also enter multiple
non-continuous values, separated by semicolons.
Idle Time: Enter the elapsed time before the Port Trigger mapping
closes for all of the listed entries.
To edit or remove an entry, select it and then click Edit or Remove to
perform the action.
Networking - Virtual Server
The Virtual Server sets up an automatic inbound forwarding
mechanism for services running on your computer, such as web
servers, email servers, or other specialized applications. When you
use this service, it is suggested that you use Static IP and not DHCP,
because the DHCP server may change the IP address during usage.
You may use DHCP and then reserve the IP address.
The table below lists the current Port Forwarding rules. To access the
screen, click Networking > Virtual Server. Click Apply to save your
settings or Cancel to cancel changes.