Motorola WR850G - Manual (Page 80)

SECTION 4 TROUBLESHOOTING
4-4 SECTION 4, TROUBLESHOOTING
I cannot access the Configuration Utility for the router.
! Verify your Ethernet connection to the router.
! Verify that the IP address of the PC being used to configure the
router is on the same network as the router’s configuration IP
address.
! The IP address of your network adapter must be on the same
network and not a duplicate of any others on the network (for
example: 192.168.10.3 and using a subnet mask of
255.255.255.0 can be used to login to the router’s default IP
address of 192.168.10.1). Refer to Section 2: Configuration >
Configure Your Computers on how to adjust the IP address for
your PC.
! Verify that you can ping the router on this IP address.
! In the Command window, type ping and your router’s default
IP address and press Enter.
! If you have changed the factory configured default IP address
of the router, you will need to set your network adapter
accordingly.
! Verify you are entering the correct URL in the browser. The
default is http://192.168.10.1 . If you think you have changed the
IP address used to configure the router and cannot remember it,
you must reset the unit back to factory defaults. To do this, press
and hold the reset button for more the 5 seconds. This clears the
router’s user settings, including User ID, Password, IP Address,
and Subnet mask.
! Once the router is reset to factory default, re-verify the Ethernet
connectivity and IP address issues.