Maxtor D540X-4K - Manual (Page 20)

Installation
3-2 Maxtor D540X-4K 20.4/40.0/60.0/80.0 GB AT
 702#%-+0) +05647%6+105
1. Open the shipping container and remove the packing assembly that
contains the drive.
2. Remove the drive from the packing assembly.
3. When you are ready to install the drive, remove it from the ESD bag.
Figure 3-2 shows the packing assembly for a single Maxtor D540X-4K hard disk
drive. A 20-pack shipping container is available for multiple drive shipments.
(KIWTG   Drive Packing Assembly
%#76+10 The maximum limits for physical shock can be exceeded if the
drive is not handled properly. Special care should be
taken not to bump or drop the drive. It is highly recommended
that Maxtor D540X-4K drives are not stacked or placed on any
hard surface after they are unpacked. Such handling could cause
media damage.
%#76+10 During shipment and handling, the antistatic electrostatic dis-
charge (ESD) bag prevents electronic component
damage due to electrostatic discharge. To avoid accidental dam-
age to the drive, do not use a sharp instrument to open the ESD
bag and do not touch PCB components. Save the packing mate-
rials for possible future use.