Maxtor D540X-4K - Manual (Page 30)

Installation
3-12 Maxtor D540X-4K 20.4/40.0/60.0/80.0 GB AT
 &% 2QYGT , 5GEVKQP #
The recommended mating connectors for the +5 VDC and +12 VDC input power
are listed in Table 3-2.
6CDNG   J1 Power Connector, Section A
Note: Labels indicate the pin numbers on the connector. Pins 2 and 3 of
section A are the +5 and +12 volt returns and are connected together
on the drive.
 'ZVGTPCN &TKXG #EVKXKV[ .'&
An external drive activity LED may be connected to the DASP-I/O pin 39 on J1.
For more details, see the pin description in Table 6-1.
 #6# $WU +PVGTHCEG %QPPGEVQT , 5GEVKQP %
On the Maxtor D540X-4K 20.4/40.0/60.0/80.0 GB AT hard disk drives, the ATA
bus interface cable connector (J1, section C) is a 40-pin Universal Header, as shown
in Figure 3-9.
To prevent the possibility of incorrect installation, the connector has been keyed by
removing Pin 20. This ensures that a connector cannot be installed upside down.
See Chapter 6, “ATA Bus Interface and ATA Commands,” for more detailed
information about the required signals. Refer to Table 6-1 for the pin assignments
of the ATA bus connector (J1, section C).
2+0
07/$'4
81.6#)'
.'8'.
/#6+0) %100'%614 6;2' #0& 2#46 07/$'4
14 '37+8#.'06
J1 Section A (4-Pin):
1 +12 VDC 4-Pin Connector:
AMP P/N 1-480424-0
Loose piece contacts:
AMP P/N VS 60619-4
Strip contacts:
AMP P/N VS 61117-4
2 Ground
Return for
+12 VDC
3 Ground
Return for
+5 VDC
4 +5 VDC