Microtek MHP1-HD - Manual (Page 25)

25
42" PLASMA DISPLAY
Specifications for Computer Modes
For most settings, the computer uses Plug and Play technology to adjust itself to the settings of the
PDP. For certain settings, however, the size and position of the image shown on the PDP may be
determined by the computer. The following table shows display elements determined by the computer
and supported by the PDP.
Supported Display Elements
NOTE:
•
Select only standard display formats in your computer. If you select non-standard display formats,
the PDP may not display them properly.
• For WXGA formats, 1280 x 768 is the lone supported display resolution.
• If your computer has vertical and horizontal frequency selection, select 60 Hz (vertical) and 31.5
kHZ (horizontal).
• Interlaced refresh is not supported.
Display Mode
Analog
Horizontal Frequency Vertical Frequency
VESA
VGA
640 x 480
31.5 KHz 60.0 Hz
37.5 KHz 75.0 Hz
720 x 400 37.9 KHz 85.0 Hz
640 x 480 37.9 KHz 72.0 Hz
SVGA 800 x 600
35.2 KHz 56.3 Hz
37.9 KHz 60.3 Hz
46.9 KHz 75.0 Hz
48.1 KHz 72.0 Hz
XGA 1024 x 768
48.4 KHz 60.0 Hz
56.6 KHz 70.0 Hz
60.0 KHz 75.0 Hz
SXGA 1280 x 1024 64.0 KHz 60.0 Hz
Macintosh VGA
640 x 480 35.0 KHz 66.7Hz
832 x 624 49.7 KHz 74.6 Hz
MS-DOS 640 x 350 31.5 KHz 70.1 Hz