MITSUBISHI ELECTRIC WD-62530 - Manual (Page 20)

20 Chapter 2. TV Connections
Before You Begin
Choosing a Language for Menus
When you first power on the TV, you can select either
English or Spanish for all menus. You can later change
the language through the Setup menu.
Figure 1. The Welcome screen lets you change the menu
language when you first power on the TV.
ClearThought ® Easy Connect Auto Input
Sensing
ClearThought automatically recognizes the devices you
connected to TV inputs. The first time you connect each
device you will be prompted to identify it by selecting
from a pre-set list of device names.
Only the names of input devices currently connected will
appear in the Input Selection Menu. This makes it easy
for you to know which input devices are available for you
to use.
The table below defines how connections on each TV
jack are handled.
Auto Detection Active No Auto Detection
INPUT 1, 2, 3 video jacks ANT 1/ANT 2
COMPONENT 1 & 2
video jacks RECORD OUTPUT
(all jacks)
HDMI* 1 & 2 All AUDIO jacks
* If the device is powered off when connected, detec-
tion will occur when the device is next powered on.
Figure 2. The Auto Input Sensing screen appears when a
device is first detected. Select a name for the connected
device in this screen.
1. Connect your devices to the TV.
The TV and the devices can be either on or off when
connecting. If the TV is powered off, the detection
process will occur the next time you turn on the TV.
2. When the Auto Input Sensing screen opens (figure 2),
you can accept the default name or press to
select from a list of device names (e.g., cable box,
DVD, Satellite, VCR).
Choose a name that will help you when selecting
inputs in the Input Selection menu.
3. Press EXIT to close the screen. If you connected
several devices at the same time, the screen for the
next connection will open.
More About Auto Input Sensing
• You can change the input name at a later time using
the Input Name menu.
• If you disconnect a device and then later connect a
different device to that jack, open the Input Name
menu to update the device name.
• Antenna inputs ( ANT 1/ANT 2), all audio and all
Record Output jacks are never detected.
• Be careful to choose different names for each input.