MITSUBISHI ELECTRIC WD-62530 - Manual (Page 42)

42 Chapter 4. TV Menu Settings
Clock (Setup Menu)
Set the clock if you wish to use the TV’s Timer function
or schedule delayed recordings. You can use either the
manual or auto method to set the clock.
Figure 3. Clock submenu
Setting the Clock Manually
Time
With the hour highlighted in yellow characters, press
repeatedly to slowly increment the hour and associated
AM/PM indicator or press and hold to quickly increment
the hour. Press
ENTER to highlight the minutes in yellow.
Press to set the minutes. Press to move to the
Time box.
Date
With the month highlighted in yellow characters, press
to select the correct month. Press ENTER to highlight
the day. Press to select the correct day. Press ENTER
to highlight the year. Press to select the current
year. Press to move to the
Date box.
Time Zone
Select your correct time zone. Press or to select
the time zone for your area (
Atlantic, Eastern, Central,
Mountain, Pacific, Alaska or Hawaii). Press to move
to the
Daylight Savings option.
Daylight Savings
Press or to select either
Applies or Ignore, depend-
ing on whether or not daylight savings time is used in
your area.
Note: If Clock Setting is set to Manual, you must manu-
ally set the TV’s clock ahead or back each time
the time change occurs.
If you have selected Auto for Clock Setting, the TV’s
clock adjusts automatically to daylight savings time.
Setting the Clock Automatically
Select the Time Zone and the Daylight Savings (DST)
options for your state. Press to select Applies or
Ignore. You may then tune to a channel on ANT 1 or
ANT 2 that uses Extended Data Service (XDS) time
Setup Menu
Figure 2. Setup menu
Language (Setup Menu)
Choose to display the on-screen menus in either English
or Spanish (Español).
To listen to audio in other languages (when available), see
the Audio Settings section in this chapter.
Memorize Channels (Setup Menu)
For ANT 1/MAIN and ANT 2/AUX
The memorization process performs two scans of all local
channels on the selected
ANT input. Analog channels
are scanned first, then the process is repeated for digital
channels. Channel memorization may take up to 15
minutes to complete.
To start channel memorization
1. Highlight an input selection based on your connec-
tions:
Input Condition
Ant 1 Air,
Ant 2 Air When connected to an indoor/outdoor
antenna
Ant 1 Cable,
Ant 2 Cable When connected to direct cable (no
cable box)
2. Press ENTER to start automatic channel memorization.
To stop channel memorization before completion
Press CANCEL.
Channels memorized before you pressed CANCEL are
retained in memory. If you restart memorization, all previ-
ously memorized channels for the selected antenna input
are erased and the process starts over from the begin-
ning.
After channel memorization, press CH / to tune
to memorized channels. Select the Channel menu for
further channel editing, such as adding and deleting
channels from memory, naming channels, and saving
favorite channels in custom memory banks.