MITSUBISHI ELECTRIC WD-62530 - Manual (Page 78)

78 Appendices
Reset Name When to Use How to Use Resulting Action
Parental Lock
Pass Code To change your Parental
Lock Pass Code This information is listed on the cutout page in
Appendix A. Please refer to that page. Allows a new code to be
established.
Front-Panel Lock
Release To re-enable the front-
panel controls after
activation of the Front-
Panel Lock • When Energy Mode is set to Fast
Power On, press and hold the MENU
button on the front panel for over eight
seconds.
• When Energy Mode is set to Low
Power, press POWER on the front panel to
turn on the TV. Press and hold the
MENU
button on the front panel for over eight
seconds.
Allows the front panel to be
unlocked if the remote control is
misplaced.
System Reset If the TV does not turn on
or off, does not respond
to the remote control or
front panel buttons, or
has audio but no video. Press the SYSTEM RESET button on the front
panel with a pointed object such as the
point of pencil or end tip of a paperclip.
The TV will turn off and the green LED
will flash quickly for about one minute.
When the green LED stops flashing,
you may turn on the TV. The changes
you made most recently, before using
SYSTEM RESET, may be lost. Changes
you made previously, however, are
not lost.
TV Reset
IMPORTANT:
Use this reset
only if all other
resets have been
unsuccessful. To reset all consumer-
accessible settings
and all memories to the
original factory defaults.
CAUTION: All owner-
performed setups and
adjustments will be
erased.
1. While viewing the TV, press MENU to
display the TV Main menu.
2. With the Main menu displayed, press
number keys 1 2 3 to display the
Reset Menu.
3. READ THE ON SCREEN WARNING
AND INSTRUCTIONS.
•
If you do not wish to use this reset,
press
EXIT or MENU to back out.
• If you do wish to use the reset,
press
ENTER to erase all memories
and settings.
The TV will start the initialization
process. The TV will then turn off
and the front green LED will start
flashing. When the LED stops
flashing, you can turn the TV on
again. The Parental Lock Access
code will remain unaffected, but
all other memories and settings
outlined in this Owner’s Guide will
need to be set again.
Service and Support
Service
If you are unable to correct a problem with your TV,
consult your Mitsubishi dealer or Mitsubishi Consumer
Relations at (800) 332-2119.
• DO NOT adjust any controls other than those
described in this Owner’s Guide.
• DO NOT remove the protective back cover of your
TV.
Support
• To order replacement or additional remote controls,
lamp cartridges, or Owner’s Guides, visit our website
at www.mitsuparts.com or call (800) 553-7278.
• For questions:
Call Consumer Relations at 800-332-2119.
E-mail: [email protected]
Website: www.mitsubishi-tv.com
Important
All lamps replaced under warranty must be returned
to Mitsubishi where they will be inspected for defect
verification.
Appendix D: Troubleshooting, continued