MITSUBISHI ELECTRIC WD-62530 - Manual (Page 53)

Chapter 4. TV Menu Settings 53
Audio/Video Menu
Figure 13. Audio/Video Menu
A/V Memory Reset
A/V Memory Reset allows you to reset a specific input’s
A/V settings to the original factory settings. Highlight the
box and press to select the input name. Next press
ENTER.
The audio settings of Balance, Listen to, and Language
are general TV settings unaffected by A/V Memory Reset.
To reset all A/V settings at once, including the three
general settings, perform an A/V Reset by pressing the
front-panel buttons
GUIDE and FORMAT simultaneously.
Settings (Audio and Video)
Each input or device has its own A/V memory. Press
to select the input or device in the A/V Memory Reset
box, then select Audio or Video to adjust individual
settings. Press ENTER to close the menu and display the
individual settings.
Use to cycle through the individual settings. Use
to change the setting values. Press EXIT to return to
normal TV viewing. For descriptions of the individual A/V
settings, see the following pages.
Video Mute
The default is On, which displays a blue background when
no signal is being received on the INPUT, COMPONENT,
or HDMI jacks.
Film Mode (480i signal only)
Auto is the default setting. With Auto selected, the TV
automatically detects and applies film-decoding correc-
tion for images that originated on 24-frame-per-second
film cameras and were converted to 30-frame-per-second
video for broadcast (3:2 pulldown conversion). Try the
Off setting if the TV adds noticeable jagged edges to the
images.
When the original video was filmed on 30-frame-per-
second cameras, the
Auto setting automatically applies
video decoding, the same as used with the Off setting.
Film Mode is not effective for high-definition signals.
TV Speakers
This selection turns the TV’s internal speakers on or off.
Select Off when sending the sound through a separate
stereo system or surround sound A/V receiver.
Note: To prevent damage from a sudden increase in vol-
ume, turn the TV volume down low before chang-
ing this option to
On.
Audio/Video Settings and the Remote Control
To adjust individual audio or video settings directly with
the remote control:
1. Press AUDIO, VIDEO, or repeatedly to cycle through
the available settings.
2. Press to adjust the setting. The setting display
will disappear after five seconds of inactivity.