Wall outlet cable (no cable box), Antenna with a single lead, Antennas with separate uhf and vhf leads – MITSUBISHI ELECTRIC WD-62530 User Manual

Page 23: Chapter 2. tv connections, Figure 5. wall outlet cable

Advertising

Chapter 2. TV Connections

Wall Outlet Cable (no cable box)

It is very important to connect the incoming cable for your
primary viewing source to

ANT 1/MAIN.

1. Connect the primary incoming coaxial lead cable to

ANT 1/MAIN on the TV back panel.

2. For an optional secondary antenna source, connect

an antenna (or cable) to

ANT 2/AUX.

��

��
��

��
��
��
��

��

�

��

�

��

�

��

��
��

��

��
��

��

Figure 5. Wall Outlet Cable

Antenna with a Single Lead

For antennas with flat twin leads
Required: 300-ohm-to-75-ohm transformer.

This is not included with the TV, but is available at most

electronics stores.

1. For an antenna with flat twin leads, connect the 300-

ohm twin leads to the 300-ohm-to-75-ohm trans-
former.

2. Push the 75-ohm side of the transformer onto

ANT

1/MAIN on the TV back panel.

For cable or antenna with coaxial lead

Connect the coaxial lead directly to ANT 1/MAIN on the

TV back panel.

��

��
��

��
��
��
��

��

�

��

�

��

�

��

��
��

��

Antennas with Separate UHF and

VHF Leads

Required: UHF/VHF combiner

This is not included with the TV, but is available at most

electronics stores.

1. Connect the UHF and VHF antenna leads to the UHF/

VHF combiner.

2. Push the combiner onto

ANT 1/MAIN on the TV

back panel.

Mitsubishi strongly recommends you avoid using
antennas with flat twin leads. Flat twin lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.

��

��
��

��
��
��
��

��

�

��

�

��

�

��

��
��

��

Figure 7. Connecting separate UHF and VHF Antennas

Figure 6. Connecting a Single Antenna

Advertising

Popular Brands

Popular manuals