MITSUBISHI ELECTRIC WD-62530 - Manual (Page 51)

Chapter 4. TV Menu Settings 51
Parental Lock Menu, continued
IMPORTANT
New rating systems recognizable by the TV
may be new U.S.-based systems not included
in the original V-Chip rating system. The use
of “Canadian” in the sample screen is just
one possibility.
1. Highlight the button labeled Other Ratings on the
Parental Lock menu (figure 10) and press ENTER to open
the Other Ratings menu (figure 12).
2. Press to select On or Off.
3. If you selected On, press to move to the Rating
Group box.
Note that you can change settings only for the rating
system available on the currently tuned channel. In
the figure above, for example, the Canadian rating
system is in effect. To change settings at a later time
for the Canadian rating system, you must again tune
to a channel broadcasting the Canadian system.
4. Press to select from the subgroups available for
the rating system— English or French in this example.
5. Press to move to the Rating box.
6. Press to select the program rating level you want
to block.
7. Press ENTER to add a check mark to indicate blocking is
in effect for the rating. When a rating shows a check
mark, press
ENTER to remove the check mark and allow
programs with this rating.
8. Repeat steps 3 through 7 for each additional rating
system you would like to set up.
9. Press MENU to return to the Parental Lock menu or
press EXIT to close all menus.
Bypassing the Ratings Lock and Lock by Time
If you try to watch blocked programming, a notice appears
prompting you for a pass code. To use the TV:
• Input your four-digit pass code and press
ENTER.
• Change to a channel airing an allowed program or
change to another device.
If you try to use the TV when it is locked by time, a similar
screen appears, prompting you for your pass code.
To reactivate the rating lock or TV Lock by Time after
using the pass code, power the TV off and then on.