MITSUBISHI ELECTRIC LT-40133 - Manual (Page 27)

27 TV Operation and Features
4
Choosing a Viewing Source
Input Selection menu
Choose a viewing source from the Input Selection
menu. The current TV input appears as a full-color
icon in this menu.
1. Press INPUT to display the Input Selection menu. If
there are only two inputs to the TV, INPUT switches
between them without displaying the menu.
2. Highlight an input icon using .
3. Press
ENTER to switch to the input and close the
menu.
More About the Input Selection Menu
• To assign meaningful names to the icons, see the
Inputs > Name menu in chapter 5, “TV Menu Set-
tings.”
• To rearrange the icons, see the Inputs > Order
menu in chapter 5, “TV Menu Settings.”
Sleep Timer
The Sleep Timer turns the TV off after the length of time
you set.
Setting the Sleep Timer
1. Press
SLEEP on the remote control.
2. Press SLEEP additional times to increase the time in
30-minute increments up to the maximum of 120
minutes.
3. Press EXIT or wait five seconds without pressing any
buttons for the message to disappear.
4. Press SLEEP to view the time remaining before the
sleep timer turns off the TV.
Cancelling the Sleep Timer
1. Press
SLEEP to display the on-screen message.
2. Press SLEEP repeatedly until OFF is displayed.
Note: After five seconds of inactivity, the message box
will disappear.
TV Tips
Turning the TV On or Off
To turn the TV on or off, point the remote control at the
front lower-right corner of the TV and press the
POWER
button. Alternatively, press the POWER button on the
side panel of the TV.
Controlling Sound Volume
Press
VOL / to adjust the sound level. See also
“Controlling A/V Receiver Sound Volume” in chapter 2,
“TV Setup.”
Changing Channels (antenna sources)
To change channels:
• Enter the channel number using the number keys
on the remote control and press ENTER. For a two-
part digital channel, such as 3-1, press 3 — CANCEL 1 to
enter a dash (separator).
• Press CH/PAGE / to change channels one
channel at a time.
• Press and hold CH/PAGE / to move quickly
through channels.
• Press QV (QuickView) to switch back to the previ-
ously tuned channel.
• Press GUIDE to display ChannelView or TV Guide
Daily (model LT-40134 only) channel listings, then
highlight a channel, and press
ENTER.
• Repeatedly press FAV to cycle through channels
setup as “favorites.” See chapter 5,“Setup Menu.”
To quickly add a channel to the favorites list, tune
the TV to the desired channel, then press and hold
the
FAV key until the status display appears.
To remove a channel from the favorites list, tune
to the channel (status display appears) and then
immediately press
CANCEL. See chapter 5, “Setup
Menu” for more information.
NOTE: Memorize channels to make finding channels
easier. See the Setup > Scan menu.