MITSUBISHI ELECTRIC LT-40133 - Manual (Page 50)

50
6
NetCommand
About NetCommand
• This chapter applies to LT-40134, LT-46144, and
LT-52144 models only.
• The IR “Learning” feature of NetCommand allows
the TV to learn the remote control signals for your
A/V devices
• NetCommand setup is optional.
• You can perform NetCommand setup when the TV
first recognizes a device during Auto Input Sensing
or at any convenient time afterward.
• NetCommand operates by sending remote control
signals from the TV to your other devices via the IR
emitters, telling the devices to play, record, change
inputs, adjust volume, change channels and many
more functions. All this is accomplished with the
TV’s remote control and the slide switch left in the
TV position.
• You can choose the level of NetCommand control
for your home theater.
Standard Setup. Perform a standard setup if
you want NetCommand to control only a few
devices, such as the TV, a playback device
(like a DVD player), and a cable box. With this
setup, you can use the TV’s remote control to
operate these devices.
A/V Receiver Setup. Perform A/V receiver
setup if you want NetCommand to:
Control a surround sound A/V receiver.
Automatically change audio input selec-
tions on an A/V receiver when you change
inputs on the TV.
IMPORTANT
Be sure to connect the IR emitter cable to the
TV and properly place the emitters so that
Netcommand can control your devices. See the
explanation on the following page.