MITSUBISHI ELECTRIC LT-40133 - Manual (Page 35)

4. TV Operation and Features 35
Media Setup Menu
Media Setup menu
In the Media Setup menu you can adjust the slide
show display, number of repetitions, or display interval.
• Select either
Auto or Manual advance. During
manual operation, press or ENTER to advance to
the next slide.
• For automatic advance, select the number of times
(frequency) to play the complete slide show: Once,
Twice, or Continuous.
• For automatic advance, select the time interval for
display of each slide. The interval you select here is
the minimum time between slides; actual time may
be longer for larger files.
• Press EXIT to close the Media Setup menu and
return to the USB Photo menu.
USB Photo Menu Compatible Picture Files
• Still images recorded on digital cameras using the
Exchangeable Image File Format, version 2.1 (EXIF
2.1) standard for digital still cameras and Design
Rules for Camera File Systems version 1.0 (DCF
1.0)
• Some images opened and re-saved on a computer
may not play back or may not display in the thumb-
nail list. This happens if the files were re-saved in
an incompatible format.
• Full path file names can be no longer than 50 char-
acters and must end in a .jpg extension. Only the
first 20 characters will be displayed.
• Images on storage devices with a capacity of over
256 MB can take a longer initial time to display.
Slide Show
Use these keys during the slide show:
Keys for JPEG Picture Slide Show
Begin or resume slide show playback
Pause or resume playback while in auto-
matic advance mode.
or
ENTER
Advance to the next slide.
Go to the previous slide.
F ORMAT Rotate the slide clockwise in 90˚ incre-
ments.
Stop slide show and display the
USB Photo
menu.
INFO Display status for the viewing device and
current image.
INPUT Display the Input Selection menu.
MENU Display or remove the TV Main menu.
Note: Always press (STOP) to stop slide show play-
back before disconnecting from the USB Photo
port.
Photos and Moving Video as Composite
Video
Connect the camera to the TV using a composite video
cable if:
• You are unable to see images using the USB photo
port.
• You wish to view moving video from the camera.
The TV’s USB Photo menu will be unavailable and
you must control the slide show through the camera.
Display resolution is standard-definition (480i).
1. Refer to the owner’s manual supplied with the
camera for instructions needed for this setup.
2. Set the camera’s output signal type to NTSC and
put the camera into playback mode.
3. With the
camera still
turned on,
connect
your digital
camera’s
composite
video cable
(usually
yellow) to
the
INPUT 3
Y/VIDEO jack
on the side
of the TV.
To hear audio, connect the camera’s audio output
cable to the
INPUT 3 - L jack.
4. When the Auto Input Sensing screen displays,
press EXIT or assign the name Camcorder.
5. Press INPUT to display the Input Selection menu.
6. Highlight the camera input icon and press ENTER.
7. If viewing photos, advance through the images
manually or set the camera to advance automatically.
IMPORTANT
The TV can read JPEG files as created by the
camera. If you edit a picture file on a computer
and re-save the image, the TV may be unable to
read the re-saved file.
.PEFM
-5
0OMZ
$PNQPTJUF

7JEFP
$BCMF
0QUJPOBM

"VEJP
$BCMF

Camera connection using a
composite video cable