MITSUBISHI ELECTRIC LT-40133 - Manual (Page 79)

Appendices 79
Appendix E: Troubleshooting, continued
TV Channels
Symptom
Remarks
1. The TV takes several seconds to respond to
channel changes. • It is normal for digital channels to take longer to tune in.
• Press ENTER after a entering channel number to avoid delays.
• Use a 4-digit number for an over-the-air digital channel.
• Use a 6-digit number for digital cable channels if your cable
service is able to recognize 6-digit channel numbers.
2. You cannot access a channel. • Use number keys instead of CH/PAGE / .
• Be sure the channel you want to view is in memory. See
Setup > Scan in chapter 5, “TV Menu Settings.”
• Check that the TV is switched to the correct device or
antenna for that channel by pressing the INPUT button.
• Make sure Channel Lock is off.
• Make sure the Lock > Parent menu lock is set to off.
• If you cannot tune to a virtual digital channel even though
the TV has already memorized digital channels, tune to the
physical channel number used by the broadcaster. The
virtual channel will then be automatically added to memory.
3. Name options are not available for some
channels. You can name only memorized analog channels and memorized
digital channels not named by the broadcaster or TV Guide
Daily..
4. When ChannelView™ list is displayed, infor-
mation appears incomplete • Available information is sent from the broadcaster or cable
provider. No other data is available.
• Make sure the TV clock is set correctly.
General TV Operation
Symptom
Remarks
1. The TV remote control does not work. • Check that the batteries are fresh and installed correctly.
• Check that the slide switch on the remote is set to TV.
• Be no more than 20 feet from the TV when using the remote
control.
• Program remote control to operate the TV or other device.
• Reset the remote control.
2. The TV remote POWER button blinks five times. Batteries in the remote are low and should be replaced.
3. TV does not respond to the remote control or
to side panel controls and TV will not power
on or off. Use the System Reset button.
4. When a device is selected from the Input
Selection menu, the screen is blue (no signal
source). • Make sure the selected device is turned on.
• If the device is a VCR, begin play of the VCR.
5. You have forgotten your Lock menu pass code. See Appendix B, Bypassing the Parental Lock.
6. Rating restrictions are not working. Open the Parental Lock menu and:
• Verify that the U.S. Ratings or Other Ratings setting is On.
• Check the Lock Time/Unlock Time to check if rating restric-
tions are disabled.
• Rating restrictions apply only to content on ANT 1 and ANT
2, INPUT 1–3.
7. On-screen displays appear each time you
change a function. Normal TV operation.